I had planned to build a set of bespoke shelves that would allow me to put the servers above the machines rather than below them as you see here. However that didn't quite work out so in order to be able to actually get these inside before it gets cold I got a pair of shelves from Super Cheap Auto in town
The next thing I am looking for is an old monitor that I can connect to the computer for the Lathe so I can control it and ideally a rack mount cabinet that I can fit both of the servers in along with the switch so that the cables are a bit neater and I can put them away from any possible shavings that might be leaking out of the machines.
I have a few things coming up. We got some good photos at the Lakemac Heritage festival so I will be sharing those. These CNCs will be running again very soon and I have a few things I would like to make with them that might actually happen now. And I have a Hard drive that I have been asked to destroy for data security so I will go through the details of construction with that.